12 Volt Permanent Magnet Alternator Stator Coil for DIY Wind Turbine PMA

Description

YOU ARE BUYING A NEW 12 VOLT STATOR COIL ONLY
(for a permanent magnet alternator)
These are the same stator cores we use in our PMAs
they will also fit a delco remy 10si or 12si alternator case
These stator cores are
SPECIFICALLY
wound for wind turbine use
Click here for our L-Flux 14 magnet rotor
FITS THE DELCO TYPE BOLT PATTERNS.
3 PHASE AC OUTPUT ONLY
(THE MOST EFFICIENT)
MAKE SHORT AND LONG RUNS WITH NO POWER LOSS
LIKE WELDING CABLE HAS.
IF YOU ALREADY HAVE A DELCO, THIS WILL REPLACE IT.
YOU CAN USE A SIMPLE EXTENSION CORD 12/2 WITH GROUND (3 WIRE)
INSTEAD
OF COSTLY AND HEAVY WELDING CABLE TO WIRE IT UP.
1 CABLE INSTEAD OF 2.
7 AND 14 MAGNET ROTORS.
Components in diagram below do not come with your order. It is an example of how a system would go together.
CLICK HERE TO SEE OUR FULL LINE OF WIND AND SOLAR PRODUCTS!
We do not mark items as gifts or under report values for customs. For International buyers,
it is strongly recommended to check your own country's tax practices as we do not
pay your taxes, duty or customs fees.
We do not over charge for shipping; it is simply what the shipping calculator comes up with.
Customs fees or taxes are not included in shipping, it is your responsibility to pay them.
UPS orders shipped signature required at our discretion!! Contact us right away if you need to make other arrangements!
Products may be slightly different than the ones pictured. If our supplier runs short of the products shown, we will substitute them for the same quality or better.